Gap Between Edge Of Roof And Edge Of Gutter

Home centers sell rolls of 6 in.

Gap between edge of roof and edge of gutter.

Does not address our recommended best practice of drainage gap for drip edge installation on roofs. I have a 30 year old house which i have owned for the last five years. You must have some odd water where you are if it flows up hill. The 3 would be the distance measured from the drip edge the point at which the water falls from the roof to the top of the gutter.

I don t have gap all around just in some areas. If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. Looking right down the line of the guttering the gap between the end of the last roof tile and the outer edge of the guttering varies from around an inch and half to in some cases millimetres. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.

Other than being old and rusty they are working fine based on my obser. Once the apron s in place fasten it with sheet metal screws. When you choose a reliable roofing contractor you can feel confident that you are getting the work done right the first time. I have gutters all the way around shingles overhang 1 1 5 get good flow to gutters.

Drip edge flashing directs roof runoff away from the roof fascia and edge and into gutters or at least not down the fascia board if no gutters are installed and it is recommended by roofing standards manufacturers and experts. For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house. When water drips between the fascia and the gutters the problem could be a compromised drip edge but it s also possible the gutters are overflowing. My issue since not on contract and i did not check life lesson.

Since the gutters have to slope down towards the downspout this distance will increase as you get closer to the downspout. What are some solutions to cover the gap between the roof deck and the fascia board.