Gap Between Gutter And Fascia

Gap between gutters and fascia board how easy is this to fix.

Gap between gutter and fascia.

The fascia is the wide board that s installed on edge and runs horizontally along the edge of the roof. My issue since not on contract and i did not check life lesson. Fascia boards attach to rafter ends along the roof line. If water gets trapped.

How to seal fascia gaps in a roof. Water leaking between gutter and fascia. Maintain the perfect roof drainage gap between gutter and fascia. If you don t seal them properly water can run off the roof and into your home.

I don t have gap all around just in some areas. I just got a new roof new siding and new gutters. The 2 75mm embossed standoffs allow water to escape through the gap between the gutter and the fascia rather than flowing back into the building. When used with compatible stratco gutters see brochure table 2 0 the continuous overflow fascia offers a continuous overflow.

The gutters are getting old and i want to replace all. I recently had roof replaced and did not have drip edge installed. When water drips between the fascia and the gutters the problem could be a compromised drip edge but it s also possible the gutters are overflowing. The gutters then direct the water to a downspout allowing the water to run down until it reaches the ground.

But what happens when your roof s gutters become worn out or cracked or clogged. I can see sky when i stand under the gutter and look straight up. Upon closer inspection it was obvious that there was a large gap that had developed. The water travels to.

When there is rain the water is expected to roll down the roof and into the gutters. The soffit is the flat panel that covers the underside of the rafters between the back of the fascia and the outside of the house wall. There is a gap between the gutters and the fascia. Its top edge is tucked up under the shingles and its outside face is where the gutter is mounted.

Surely this is not how it should be. What are some solutions to cover the gap between the roof deck and the fascia board. For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house. Other than being old and rusty they are working fine based on my obser.

Use tin snips to cut the gutter apron flashing roll in two 3 in. Home centers sell rolls of 6 in. When it rains water pours through that gap and splashes on the window screens. I have a 30 year old house which i have owned for the last five years.

I have called the contractor and i am waiting for a return call.