Measure the length of the gap and cut a piece of foam backer rod to match the length.
Gap between wall and roof.
I recently had roof replaced and did not have drip edge installed.
And i was advised that that gap should be protected by a home inspector.
The royal society for the protection of birds encourage builders to make provision so that critters can enter your roof to nest.
What are some solutions to cover the gap between the roof deck and the fascia board.
Smooth the caulk bead with your finger and begin caulking the joint between the fascia board and the soffit also known as the eave.
I don t have gap all around just in some areas.
If you meant an eave gap under an entirely new roof between the top of the wall and the underside of the roof that might well be especially if between the rafters or truss rafter tails your eave ventilation gap which for a ventilated unheated unair conditioned attic provides ventilation air to control heat and moisure buildup.
Usually there is a piece of metal flashing that is layered into the roofing plies and turned vertically up the wall.
Choose one that fits snugly into the gap.
It s a simple gable roof with vents at either end and a ridge vent.
The backer rod is available in a variety of thicknesses.
But where the wall sheathing meets the roof sheathing there is a gap of approximately 1 8 of an inch.
The house does not have an overhang.
The flashing that covers the joint space between the wall above and the roof below is called counter flashing.
In both headwall and sidewall conditions unless the exterior wall is brick you should see a gap of at least 1 inches between the bottom of the exterior wall covering material and the top of the roof covering material.
I have gutters all the way around shingles overhang 1 1 5 get good flow to gutters.
You ll often see exterior wall coverings installed right down on top of the shingles.
Slowly move down the joint to apply a steady bead of caulk into.
My issue since not on contract and i did not check life lesson.