Resetting the limit switch will stop your garage door from behaving erratically.
Garage door keeps reopening.
The button can easily get dirty and stuck in the pushed position.
To troubleshoot the garage door opener button make sure it s clean and free of debris.
This is actually a very rare problem of all the garage door installation problems you can have but when it happens it s usually a short in the circuit board says andrew richards owner of legacy garage doors an atlanta area garage door repair company.
This is almost always the result of a dirty or obstructed safety feature.
Also try unplugging the garage door opener and re plugging the unit back into the outlet.
One regular garage door issue many homeowners face is clicking the control panel to close your door only to have it immediately reopen once it reaches the floor.
In some rare cases a garage door will open or close by itself even if the homeowner hasn t instructed the automatic garage door opener to do so.
To try and correct the problem make sure the eyes on the sensors are clean the wire connections are securely fastened at the sensors and motor head and the eyes are directed at each other.
The garage door is likely the most used entryway to your home and it s essential to keep this fixture regularly maintained to ensure lasting safety convenience and peace of mind.
This will cause the door to open and close until the button becomes unstuck.
When the garage door opens about halfway or 5 feet from the.
Clean the button as well as the connections in the housing if this is the case.
It goes partway down reverses direction and goes back up again.
The photo eyes send an infrared beam across the bottom of your garage door opening if that beam is broken the door will reverse.
You push the button to close the garage door.
Photo eyes or safety sensors are mounted to the track on either side of the garage door about 6 inches up from the ground.
If it closes only partway the safety sensors are usually responsible clean the lenses or realign them and make sure there are no obstacles blocking the beam.
If it closes before that distance has been traveled it thinks something is wrong and it reopens to help prevent any damage or safety risk.
Open the garage door and watch it closely as it opens.