Garage Door Not Closing All The Way On One Side

The extension springs are evenly matched and installed to keep the garage door properly aligned so that it runs smoothly throughout the entire length of the track and closes evenly.

Garage door not closing all the way on one side.

Depending on the brand. First check the sensor lights. The reasons your garage door has a gap in it could be. They both have lights and both lights should be on.

In an opposite situation you may find that your garage door isn t opening all the way when you push the button on the opener so that you can drive in. Garage floor may have cracked or shifted 2. If there s something blocking the door from closing all the way a full close will be impossible. There is one on each side of the door.

Though this problem should be obvious it shouldn t be overlooked. Garage door opener malfunction or door has shifted. One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door. If it was opening too quickly move it to the next lower hole.

One or more of these reasons is likely responsible for your garage door closing partially but not all the way. Adjust the springs on both sides of the door the same way. Clutter or obstructions that block the sensor are the first problems to look for if your door won t close or in extreme cases open at all. Side mounted extension springs are installed above the horizontal roller tracks on both sides of the door.

If one of them is off or blinking it means the invisible beam that tells the opener that the way is. Bottom of the door is up on one side. Click on a problem below to see the possible causes and solutions. If your garage door isn t closing all the way but also doesn t reverse you might need to adjust something called the limit switch.

Garage door seal may be damaged 4. Garage door sensors may not be aligned correctly 3. There are of course many other problems that can keep your garage door from functioning properly. If the door was closing too quickly move the spring to the next higher hole on the bracket.

First you need to see what has caused this to happen. Retest the door balance as you did in step 1.